Technical Support
You can sign the maintenance contract for all our products, which will allow you to get the most out of them.
Notifications
Clear all
Topic starter
How to indicate that the slopes, if there is topsoil, cut into the existing ground instead of topsoil.
This topic was modified 3 years ago 2 times by Aplitop Team
Posted : 04/08/2021 6:59 am
Topic starter
To configure the cut-off point of the slopes, perform the following steps:
- Execute in the "command line" of the CAD: mdt8_conf_todo
- Change the value of the variable in the following screenshot to "1"
- Press the "enter" key on the keyboard and then the "OK" button.
Finally, if you Review or Edit the Road/Segment, the change in the cut point can be visualized.
If the value is set to "0", the slope will cut through the cleared terrain.
This post was modified 3 years ago by Aplitop Team
Posted : 04/08/2021 7:14 am
